Conference Paper
Conference Paper
[1]
J. Everton and S. Erlingsson,
"Characterizing the Resilient Modulus of Swedish Subgrades for Pavement Design Purposes,"
in Transportation Research Board 103rd Annual Meeting, January 7–11, 2024, Washington, DC, 2024.
[2]
L. Blomqvist et al.,
"Experimental and numerical analyses of a connection for CLT structures,"
in 13th World Conference on Timber Engineering, WCTE 2023, 2023, pp. 1154-1159.
[3]
T. Wang et al.,
"Glulam Frames Adhesively Bonded by Means of Birch Plywood Plates : Preliminary Investigations,"
in 13th World Conference on Timber Engineering, WCTE 2023, 2023, pp. 1453-1461.
[4]
M. Debertolis et al.,
"Investigation on mechanical connections with birch plywood gusset plates,"
in 19th Annual Meeting of the Northern European Network for Wood Science and Engineering, 2023, pp. 96-98.
[5]
Y. Wang et al.,
"Preliminary experimental investigations on frame corner joints built of glulam beams, birch plywood via mechanical connectors,"
in 19th Annual Meeting of the Northern European Network for Wood Science and Engineering, 2023.
[6]
Y. Wang et al.,
"Effect of moisture content on the angle-dependent edgewise flexural properties of unmodified and acetylated birch plywood,"
in Proceedings of the 18th Annual Meeting of the Northern European Network for Wood Science and Engineering (WSE), 2022.
[7]
T. Wang et al.,
"In-plane load-to-grain angle dependency of the compressive behavior of birch plywood,"
in CEM·2022 19th International Conference on Experimental Mechanics 17-21Jul 2022, Kraków, Poland, 2022.
[8]
H. Fadil, D. Jelagin and M. Partl,
"Predicting the Master Curve of Bituminous Mastics with Micromechanical Modelling,"
in RILEM International Symposium on Bituminous Materials, 2022, pp. 1473-1479.
[9]
J. Bergenudd et al.,
"Study of the dynamic response of a timber pedestrian bridge during different construction stages,"
in Conference Proceedings 4th ICTB (2022) ,ICTB 2021 PLUS 4th International Conference on Timber Bridges, 2022, pp. 167-178.
[10]
T. Wang et al.,
"The Embedment Behavior of Acetylated and Unmodified Birch Plywood,"
in Proceedings of the Tenth European Conference on Wood Modification, 2022.
[11]
E. Furuheim et al.,
"Connections for post and beam glulam structures using birch plywood plates and screws,"
in World Conference on Timber Engineering 2021, WCTE 2021, 2021.
[12]
L. Blomqvist et al.,
"Development of novel structural connections - Inspiration from furniture industry,"
in World Conference on Timber Engineering 2021, WCTE 2021, 2021.
[13]
Y. Wang et al.,
"Experimental study on an innovative timber-steel hybrid system,"
in Proceedings of the 17th Annual Meeting of the Northern European Network for Wood Science and Engineering, 2021, pp. 152-154.
[14]
Y. Wang et al.,
"Mechanical properties of acetylaetd birch plywood loaded parallel to the face grain,"
in World Conference on Timber Engineering 2021, WCTE 2021, 2021.
[15]
Y. Wang et al.,
"Mechanical properties of acetylated birch plywood loaded parallel to the face grain,"
in World Conference on Timber Engineering WCTE2021, 2021.
[16]
R. Crocetti et al.,
"Multiple shear plane connections with timber based gusset plates,"
in World Conference on Timber Engineering 2021, WCTE 2021, 2021.
[17]
T. Wang et al.,
"Multiple shear plane timber connections with birch plywood and dowel-type fasteners,"
in Proceedings of the 17th Annual Meeting of the Northern European Network for Wood Science and Engineering (WSE 2021), 2021.
[18]
J. Hallak Neilson et al.,
"Dynamic properties of two pedestrian wooden bridges including seasonal effects,"
in Proceedings of the International Conference on Structural Dynamic , EURODYN, 2020, pp. 1805-1813.
[19]
V. Ushakov et al.,
"Field evaluation of rutting in concrete pavements,"
in IOP Conference Series : Materials Science and Engineering, 2020, p. 012033.
[20]
E. Olsson, D. Elaguine and M. Partl,
"Numerical Evaluation of Crushing Resistance of Unbound Road Material,"
in Lecture Notes in Civil Engineering, 2020, pp. 201-210.
[21]
Y. Wang et al.,
"Numerical investigations on an innovative timber-steel hybrid system,"
in Proceedings of the 16th Annual Meeting of the Northern European Network for Wood Science and Engineering – WSE2020, 2020, pp. 92-94.
[22]
T. Wang et al.,
"Prediction of the tensile strength of birch plywood at varying angles to grain,"
in Proceedings of the 16th Annual Meeting of the Northern European Network for Wood Science and Engineering - WSE2020, 2020, pp. 80-82.
[23]
N. Francart, E. Sandberg and M. Erlandsson,
"Environmental Sustainability Building Criteria for an Open Classification System,"
in Cold Climate HVAC 2018 : Sustainable Buildings In Cold Climates, 2019, pp. 1005-1016.
[24]
H. Yin et al.,
"Fabrication of superamphiphobic wood surface based on silicone nanofilaments,"
in Proceedings of the 15th annual meeting of the Northern European Network for Wood Science and Engineering, 2019, pp. 135-137.
[25]
T. Vieira et al.,
"Porous pavement for reduced tyre/road noise and improved air quality - Initial results from a case study,"
in Proceedings of the 26th International Congress on Sound and Vibration, ICSV 2019, 2019.
[26]
J. Lundberg et al.,
"Calibration of the Swedish Studded Tyre Abrasion Wear Prediction Model and the Implication for the NORTRIP Road Dust Emission Model,"
in Transportation Research Board 97th annual meeting, 2018.
[27]
A. ,. V. Frolovskaia et al.,
"Experience of light thin-walled structures improvement in construction,"
in 6TH INTERNATIONAL CONFERENCE ON MECHATRONICS AND CONTROL ENGINEERING (ICMCE 2017), 2018.
[28]
E. Ghafoori Roozbahany, M. Partl and A. Guarin,
"Influence of layer thickness on the flow of asphalt under simulated compaction,"
in Bearing Capacity of Roads, Railways and Airfields - Proceedings of the 10th International Conference on the Bearing Capacity of Roads, Railways and Airfields, BCRRA 2017, 2018, pp. 1435-1441.
[29]
[30]
A. Ansell, E. Nordström and A. Guarin,
"Laboratory investigation of steel fibre reinforced sprayed concrete using a computed tomography method,"
in Eight International Symposium on SPRAYED CONCRETE - Modern Use of Wet Mix Sprayed Concrete for Underground Support, 2018, pp. 24-38.
[31]
T. Vieira and U. Sandberg,
"Negative Texture, Positive for the Environment: Results of Horizontal Grinding of Asphalt Pavements,"
in Transportation Research Board Annual Meeting 2018, 2018.
[32]
T. Vieira and U. Sandberg,
"Acoustical performance of winter tyres on two in-service road surfaces: a frequency spectrum analysis and comparison,"
in Proceedings of the Inter-Noise 2017, 2017, pp. 6825-6836.
[33]
A. Ansell, L. Ahmed and A. Guarin,
"Computed tomography as investigation method for steel fibre reinforced tunnel shotcrete,"
in XXIII Symposium on Nordic Concrete Research & Development, Aalborg, 2017, pp. 63-66.
[34]
T. Sjökvist, M. Wålinder and Å. Blom,
"Liquid sorption and swelling behaviour of Norway spruce heartwood and sapwood veneers studied by the multicycle Wilhelmy plate method,"
in Proceedings of the 13th annual meeting of the Northern European Network for Wood Science and Engineering, September 28-29, 2017, p. 140.
[35]
M. Larsson and M. Wålinder,
"Optimisation of timber structures based on weighted objectives,"
in Proceedings of the 13th annual meeting of the Northern European Network for Wood Science and Engineering , September 28-29, 2017, pp. 79-84.
[36]
A. Bekele et al.,
"Slow dynamic diagnosis of asphalt concrete specimen to determine level of damage caused by static low temperature conditioning,"
in 43rd Annual Review of Progress in Quantitative Nondestructive Evaluation, 2017.
[37]
J. Lundberg et al.,
"Texture influence on road dust load,"
in Proceedings of the 22nd International Transportation and Air Pollution Conferens, 2017.
[38]
K. Lillqvist et al.,
"THE INFLUENCE OF THERMAL MODIFICATION ON VENEER BOND STRENGTH,"
in Proceedings of the 13th annual meeting of the Northern European Network for Wood Science and Engineering, September 28-29, 2017, p. 56.
[39]
A. Falk and M. Wålinder,
"Function and design of innovative bio-based products for the building sector,"
in Structures and Architecture - Proceedings of the 3rd International Conference on Structures and Architecture, ICSA 2016, 2016, pp. 93-101.
[40]
P. Das, B. Birgisson and D. Jelagin,
"Importance of Thermal Contraction Coefficient in Low Temperature Cracking of Asphalt Concrete,"
in Proceedings of the Fifty-Ninth Annual Conference of the Canadian Technical Asphalt Association (CTAA): Winnipeg, Manitoba, 2016.
[41]
I. Onifade and B. Birgisson,
"Investigation of Energy-Based Crack Initiation Threshold from Meso-Scale Asphalt Concrete Response,"
in 8th RILEM International Conference on Mechanisms of Cracking and Debonding in Pavements, 2016, pp. 679-685.
[42]
T. Yideti, D. Jelagin and B. Birgisson,
"Moisture Distribution Model to Predict Matric Suction in Unbound Granular Materials as a Function of Fines Content,"
in TRB 95th Annual Meeting Compendium of Papers, 2016.
[43]
J. Ruponen et al.,
"Tensile-shear strength studies on self-bonded 2-ply birch veneer joint manufactured and tested by applying Automated Bonding Evaluation System (ABES) hot press,"
in WCTE 2016 - World Conference on Timber Engineering, 2016.
[44]
S. Källbom et al.,
"The influence of log soaking temperature and thermal modification on the properties of birch veneers,"
in IRG Annual Meeting, 2016.
[45]
K. Laine et al.,
"Acetylation and densification of wood,"
in 11th Meeting of the Northern European Network for Wood Science and Engineering – WSE. 14.-15.9.2015, Poznan, Poland, 2015.
[46]
K. Laine et al.,
"Hardness, set-recovery and micromorphology studies of densified and thermally modified wood,"
in The 8th European Conference of Wood Modification. 26.-27.10.2015, Helsinki, Finland., 2015.
[47]
L. Linkosalmi, K. Laine and L. Rautkari,
"Life cycle impacts of modified wood products,"
in COST action FP1407 1st conference “Life Cycle Assessment, EPDs and modified wood”. 25.-26.8.2015, Koper, Slovenia, 2015.
[48]
S. Källbom et al.,
"Surface chemical analysis and water vapour sorpion of thermally modified wood exposed to increased relative humidity,"
in The Eighth European Conference on Wood Modification (ECWM8) 2015, 2015.
[49]
S. Källbom et al.,
"Surface energy characteristics of refined fibres at different pressures,"
in Proceedings of 10th Meeting of the Northern European Network for Wood Science & Engineering (WSE 2014), 2014, pp. 134-138.
[50]
S. Källbom et al.,
"Surface energy characterization of thermally modified wood particles exposed to humidity cycling using inverse gas chromatography,"
in The Seventh European Conference on Wood Modification (ECWM7)., 2014.