Konferensbidrag
Konferensbidrag
[1]
Y. Wang et al.,
"Numerical investigations on an innovative timber-steel hybrid system,"
i Proceedings of the 16th Annual Meeting of the Northern European Network for Wood Science and Engineering – WSE2020, 2020, s. 92-94.
[2]
T. Wang et al.,
"Prediction of the tensile strength of birch plywood at varying angles to grain,"
i Proceedings of the 16th Annual Meeting of the Northern European Network for Wood Science and Engineering - WSE2020, 2020, s. 80-82.
[3]
H. Yin et al.,
"Fabrication of superamphiphobic wood surface based on silicone nanofilaments,"
i Proceedings of the 15th annual meeting of the Northern European Network for Wood Science and Engineering, 2019, s. 135-137.
[4]
T. Vieira et al.,
"Porous pavement for reduced tyre/road noise and improved air quality - Initial results from a case study,"
i Proceedings of the 26th International Congress on Sound and Vibration, ICSV 2019, 2019.
[5]
J. Lundberg et al.,
"Calibration of the Swedish Studded Tyre Abrasion Wear Prediction Model and the Implication for the NORTRIP Road Dust Emission Model,"
i Transportation Research Board 97th annual meeting, 2018.
[6]
A. ,. V. Frolovskaia et al.,
"Experience of light thin-walled structures improvement in construction,"
i 6TH INTERNATIONAL CONFERENCE ON MECHATRONICS AND CONTROL ENGINEERING (ICMCE 2017), 2018.
[7]
E. Ghafoori Roozbahany, M. Partl och A. Guarin,
"Influence of layer thickness on the flow of asphalt under simulated compaction,"
i Bearing Capacity of Roads, Railways and Airfields - Proceedings of the 10th International Conference on the Bearing Capacity of Roads, Railways and Airfields, BCRRA 2017, 2018, s. 1435-1441.
[8]
[9]
A. Ansell, E. Nordström och A. Guarin,
"Laboratory investigation of steel fibre reinforced sprayed concrete using a computed tomography method,"
i Eight International Symposium on SPRAYED CONCRETE - Modern Use of Wet Mix Sprayed Concrete for Underground Support, 2018, s. 24-38.
[10]
T. Vieira och U. Sandberg,
"Negative Texture, Positive for the Environment: Results of Horizontal Grinding of Asphalt Pavements,"
i Transportation Research Board Annual Meeting 2018, 2018.
[11]
T. Vieira och U. Sandberg,
"Acoustical performance of winter tyres on two in-service road surfaces: a frequency spectrum analysis and comparison,"
i Proceedings of the Inter-Noise 2017, 2017, s. 6825-6836.
[12]
A. Ansell, L. Ahmed och A. Guarin,
"Computed tomography as investigation method for steel fibre reinforced tunnel shotcrete,"
i XXIII Symposium on Nordic Concrete Research & Development, Aalborg, 2017, s. 63-66.
[13]
T. Sjökvist, M. Wålinder och Å. Blom,
"Liquid sorption and swelling behaviour of Norway spruce heartwood and sapwood veneers studied by the multicycle Wilhelmy plate method,"
i Proceedings of the 13th annual meeting of the Northern European Network for Wood Science and Engineering, September 28-29, 2017, s. 140.
[14]
M. Larsson och M. Wålinder,
"Optimisation of timber structures based on weighted objectives,"
i Proceedings of the 13th annual meeting of the Northern European Network for Wood Science and Engineering , September 28-29, 2017, s. 79-84.
[15]
A. Bekele et al.,
"Slow dynamic diagnosis of asphalt concrete specimen to determine level of damage caused by static low temperature conditioning,"
i 43rd Annual Review of Progress in Quantitative Nondestructive Evaluation, 2017.
[16]
J. Lundberg et al.,
"Texture influence on road dust load,"
i Proceedings of the 22nd International Transportation and Air Pollution Conferens, 2017.
[17]
K. Lillqvist et al.,
"THE INFLUENCE OF THERMAL MODIFICATION ON VENEER BOND STRENGTH,"
i Proceedings of the 13th annual meeting of the Northern European Network for Wood Science and Engineering, September 28-29, 2017, s. 56.
[18]
A. Falk och M. Wålinder,
"Function and design of innovative bio-based products for the building sector,"
i Structures and Architecture - Proceedings of the 3rd International Conference on Structures and Architecture, ICSA 2016, 2016, s. 93-101.
[19]
P. Das, B. Birgisson och D. Jelagin,
"Importance of Thermal Contraction Coefficient in Low Temperature Cracking of Asphalt Concrete,"
i Proceedings of the Fifty-Ninth Annual Conference of the Canadian Technical Asphalt Association (CTAA): Winnipeg, Manitoba, 2016.
[20]
I. Onifade och B. Birgisson,
"Investigation of Energy-Based Crack Initiation Threshold from Meso-Scale Asphalt Concrete Response,"
i 8th RILEM International Conference on Mechanisms of Cracking and Debonding in Pavements, 2016, s. 679-685.
[21]
T. Yideti, D. Jelagin och B. Birgisson,
"Moisture Distribution Model to Predict Matric Suction in Unbound Granular Materials as a Function of Fines Content,"
i TRB 95th Annual Meeting Compendium of Papers, 2016.
[22]
J. Ruponen et al.,
"Tensile-shear strength studies on self-bonded 2-ply birch veneer joint manufactured and tested by applying Automated Bonding Evaluation System (ABES) hot press,"
i WCTE 2016 - World Conference on Timber Engineering, 2016.
[23]
S. Källbom et al.,
"The influence of log soaking temperature and thermal modification on the properties of birch veneers,"
i IRG Annual Meeting, 2016.
[24]
K. Laine et al.,
"Acetylation and densification of wood,"
i 11th Meeting of the Northern European Network for Wood Science and Engineering – WSE. 14.-15.9.2015, Poznan, Poland, 2015.
[25]
K. Laine et al.,
"Hardness, set-recovery and micromorphology studies of densified and thermally modified wood,"
i The 8th European Conference of Wood Modification. 26.-27.10.2015, Helsinki, Finland., 2015.
[26]
L. Linkosalmi, K. Laine och L. Rautkari,
"Life cycle impacts of modified wood products,"
i COST action FP1407 1st conference “Life Cycle Assessment, EPDs and modified wood”. 25.-26.8.2015, Koper, Slovenia, 2015.
[27]
S. Källbom et al.,
"Surface chemical analysis and water vapour sorpion of thermally modified wood exposed to increased relative humidity,"
i The Eighth European Conference on Wood Modification (ECWM8) 2015, 2015.
[28]
S. Källbom et al.,
"Surface energy characteristics of refined fibres at different pressures,"
i Proceedings of 10th Meeting of the Northern European Network for Wood Science & Engineering (WSE 2014), 2014, s. 134-138.
[29]
S. Källbom et al.,
"Surface energy characterization of thermally modified wood particles exposed to humidity cycling using inverse gas chromatography,"
i The Seventh European Conference on Wood Modification (ECWM7)., 2014.
[30]
P. Khavassefat, D. Jelagin och B. Birgisson,
"The effect of road surface deterioration on pavement service life,"
i Expanding horizons: 13th International Symposium on Heavy Vehicle Transport Technology, San Luis, Argentina, 27-31 October 2014, 2014.
[31]
S. Källbom et al.,
"Water vapour sorption properties and surface chemical analysis of thermally modified wood particles,"
i Recent Advances in the field of TH and THM Wood Treatment, 2014.
[32]
A. Falk,
"Cross-laminated timber : Driving forces and innovation,"
i Structures and Architecture: Concepts, Applications and Challenges - Proceedings of the 2nd International Conference on Structures and Architecture, ICSA 2013, 2013, s. 511-518.
[33]
E. Chailleux och M. N. Partl,
"General summary and outlook,"
i RILEM State-of-the-Art Reports, 2013, s. 429-438.
[34]
K. Segerholm och R. E. Ibach,
"Moisture and Fungal Durability of Wood-Plastic Composites Made With Chemically Modified and Treated Wood Flour,"
i Proceedings IRG Annual Meeting, 2013, s. IRG/WP 13-40648.
[35]
S. Källbom et al.,
"Physico-chemical characterization of THM modified wood using inverse gas chromatography (IGC),"
i Evaluation, processing and prediction of THM treated wood behaviour by experimental and numerical methods, 2013, s. 35-36.
[36]
S. Källbom et al.,
"Surface energy characterization at different moisture levels of thermally modified wood using inverse gas chromatography,"
i Proceedings of the 9th meeting of the Northern European Network for Wood Science and Engineering (WSE), 2013, s. 130-135.
[37]
S. Källbom et al.,
"Surface energy characterization of thermally modified wood using inverse gas chromatography,"
i The 44th Annual Meeting of the International Research Group on Wood Preservation, 2013.
[38]
K. Segerholm et al.,
"Biological outdoor durability of WPC with chemically modified wood,"
i Proceedings of the 6th European conference on wood modification, 2012, s. 47-54.
[39]
D. Jones et al.,
"Development of a novel wood based panel for use in internal door manufacture,"
i Proceedings of the 5th International Conference on Environmentally-Compatible Forest Products, 2012.
[40]
K. Segerholm och M. Wålinder,
"Inverse gas chromatography characterization of wood composite components,"
i Proceedings of the 8th meeting of the Northern European Network for Wood Science and Engineering (WSE), 2012, s. 58-63.
[41]
K. Segerholm, R. E. Ibach och M. Westin,
"Durability of PLA - Modified Wood Composites,"
i Proceedings of the 11th International Conference on Wood & Biofiber Plastic Composites, 2011.
[42]
J. Jermer et al.,
"Durability testing of coconut shell according to ENV 807,"
i 42nd Annual Meeting of the International Research Group on Wood Protection, 2011.
[43]
E. Sidorova, S. Trey och F. Englund,
"Modification of wood with an anti-oxidant tannin derivative : preliminary study,"
i Proceedings of the 7th meeting of the Nordic-Baltic Network in Wood Material Science & Engineering (WSE) 2011, 2011, s. 161-166.
[44]
K. Segerholm, M. Wålinder och S. L. Bardage,
"Mould growth resistance of fungicide-containing WPC,"
i Proceedings of the 7th meeting of the Nordic-Baltic Network in Wood Material Science & Engineering (WSE), 2011, s. 25-30.
[45]
M. Wålinder och D. Gardner,
"Surface energy characteristics of maple wood particles coated with polystyrene-acrylic acid (PSAA) block copolymer,"
i Proceedings of the 2011 IAWS Annual Meeting on Novel Materials from Wood or Cellulose, 2011, s. 66-67.
[46]
S. Olsson et al.,
"The use of esterified lignin for synthesis of durable composites,"
i Proceedings of the 7th meeting of the Nordic-Baltic Network in Wood Material Science and Engineering (WSE), 2011, s. 173-178.
[47]
K. Segerholm, M. Wålinder och D. Holmberg,
"Adhesion studies of scots pine-polypropylene bond using ABES,"
i In Proceedings of the 6th meeting of the Nordic-Baltic Network in Wood Material Science and Engineering, WSE, 2010.
[48]
K. Segerholm och M. Wålinder,
"Dimensional changes due to water sorption in high wood-content WPCs prepared with modified wood,"
i In Proceedings of the fifth European Conference on Wood Modification, ECWM5, 2010.
[49]
M. Wålinder, K. Segerholm och M. Westin,
"Durability of high wood content WPCs,"
i Proceedings of the International Convention of Society of Wood Science and Technology andUnited Nations Economic Commission for Europe – Timber Committee, 2010.
[50]
M. Wålinder et al.,
"Liquids and coatings wettability and penetrability of acetylated scots pine sapwood,"
i In Proceedings of the fifth European Conference on Wood Modification, ECWM5, 2010, s. 381-388.